Mold manufacturing industry is high-speed processing of the important areas of application. Mold cavity processing power has always been monopolized by processing, but its low processing efficiency. Cutting force and high-speed machining small, can be 60HRC milling hardened mold steel, surface roughness value also very small; large shallow cavity mold radius Renmu rate, fully available to replace the high-speed milling EDM: deep cavity of small curvature, high-speed milling process can be used as a rough and semi-finishing, electrical processing only as a finishing. This will enable the production efficiency greatly improved cycle. Steel cutting speed of up to 600 a 800m/min. High-speed cutting for mold manufacturing provides new opportunity for the development. It simplifies the processing means of shortening the processing cycle and improve the processing efficiency, reduced processing costs, at present it to a higher agility, intelligence, integrated development, becoming the third generation of modeling technology.
